Honeywell XENON 1902 - Manual (Page 70)

3 - 8
Base Power Communication Indicator
To display the power indicator on a base or an Access Point, scan the Base
Power Communication Indicator On bar code. To turn off the power indi-
cator, scan the Off bar code.
Default = On.
Reset Scanner
Scanning this bar code reboots the scanner and causes it to relink with the
base or Access Point.
Scanning While in Base Cradle
Note: This feature does not apply to the Access Point.
If you want to be able to scan bar codes while the scanner is in the base cradle,
scan the Scanning in Cradle On bar code below. If you want to only allow
scanning when the scanner is out of the base cradle, scan Scanning in Cradle
Off. If you want the scanner to shut down when in the base cradle, scan Shut
Down Scanner in Cradle.
Default = Scanning in Cradle On.
* Base Power Communication
Indicator On
Base Power Communication
Indicator Off
Reset Scanner
Scanning in Cradle Off
* Scanning in Cradle On
Shut Down Scanner in Cradle