Honeywell 2020 - Manual (Page 42)

1 - 24
For additional USB programming and technical information, refer to Honeywell
“USB Application Note,” available at
www.honeywell.com/aidc .
Note: Without using the 9-volt external, power supply, the base only uses
enough power from the host to operate the interface. The image
scanner’s battery is not charged when in this mode. Using the 9-volt,
external power supply allows the image scanner’s battery to be charged,
and no power is drawn from the host.
IBM SurePos
Scan one of the following “Plug and Play” codes to program the 3820/3820i for
IBM SurePos (USB Hand Held image scanner) or IBM SurePos (USB Tabletop
scanner).
Note: After scanning one of these codes, you must power cycle the cash
register.
Each barcode above also programs the following suffixes for each symbology:
USB PC or Macintosh Keyboard
Scan one of the following codes to program the 3820/3820i for USB PC Key-
board or USB Macintosh Keyboard. Scanning these codes adds a CR and LF,
along with selecting the terminal ID (USB PC Keyboard - 124, USB Macintosh
Keyboard - 125, USB Japanese Keyboard (PC) - 134).
Symbology Suffix
EAN 8 0C
EAN 13 16
UPC A 0D
UPC E 0A
Code 39 00 0A 0B
Interleaved 2 of 5 00 0D 0B
Code 128 00 18 0B
IBM SurePos (USB Hand
Held Image Scanner)
Interface
IBM SurePos (USB Tabletop
Scanner) Interface