Honeywell 2020 - Manual (Page 73)

3 - 11
5. End Output Sequence Editor
Scan F F to enter an Output Sequence for an additional symbology, or Save
to save your entries.
Other Programming Selections
• Discard
This exits without saving any Output Sequence changes.
Output Sequence Editor
Require Output Sequence
When an output sequence is Required, all output data must conform to an edited
sequence or the image scanner will not transmit the output data to the host
device. When it’s
On/Not Required, the image scanner will attempt to get the
output data to conform to an edited sequence, but if it cannot, the image scanner
transmits all output data to the host device as is.
When the output sequence is Off, the barcode data is output to the host as the
image scanner decodes it.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Enter Sequence
Default Sequence
Required
On/Not Required
* Off