Code 39 check character, Code 39 message length, Code 39, continued – Honeywell 2020 User Manual
Page 94
6 - 6
Code 39, continued
Code 39 Check Character
No Check Character indicates that the image scanner reads and transmits
barcode data with or without a check character.
When Check Character is set to Validate, but Don’t Transmit, the unit only
reads Code 39 barcodes printed with a check character, but will not transmit the
check character with the scanned data.
When Check Character is set to Validate and Transmit, the image scanner
only reads Code 39 barcodes printed with a check character, and will transmit
this character at the end of the scanned data.
Default = No Check Character.
Code 39 Message Length
Scan the barcodes below to change the message length. Refer to
on page 6-2 for additional information. Minimum and Maximum
lengths = 0-48. Minimum Default = 0, Maximum Default = 48.
Validate, but Don’t Transmit
* No Check Character
Validate and Transmit
Minimum Message Length
Maximum Message Length