Serial programming commands, Conventions, Menu command syntax – Honeywell 3800gPDF User Manual

Page 113: Chapter 11 - serial programming commands, Conventions -1 menu command syntax -1, Chapter 11

Advertising
background image

3800g/3800gHD/3800gPDF User’s Guide

11 - 1

11

Serial Programming Commands

The serial programming commands can be used in place of the programming
bar codes. Both the serial commands and the programming bar codes will pro-
gram the 3800g. For complete descriptions and examples of each serial pro-
gramming command, refer to the corresponding programming bar code in this
manual.

The device must be set to an RS-232 interface (see

page 1-7

). The following

commands can be sent via a PC com port using terminal emulation software.

Conventions

The following conventions are used for menu and query command descriptions:

parameterA label representing the actual value you should send as part of a

command.

[

option] An optional part of a command.

{Data}

Alternatives in a command.

bold

Names of menus, menu commands, buttons, dialog boxes, and

windows that appear on the screen.

Menu Command Syntax

Menu commands have the following syntax (spaces have been used for clarity
only):

Prefix Tag SubTag {Data} [, SubTag {Data}] [; Tag SubTag {Data}] […] Storage

Prefix

Three ASCII characters: SYN M CR (ASCII 22,77,13).

Tag

A 3 character case-insensitive field that identifies the desired menu
command group. For example, all RS-232 configuration settings
are identified with a Tag of 232.

SubTag

A 3 character case-insensitive field that identifies the desired menu
command within the tag group. For example, the SubTag for the
RS-232 baud rate is BAD.

Data

The new value for a menu setting, identified by the Tag and Sub-
Tag.

Storage

A single character that specifies the storage table to which the
command is applied. An exclamation point (!) performs the com-
mand’s operation on the device’s volatile menu configuration table.
A period (.) performs the command’s operation on the device’s
non-volatile menu configuration table. Use the non-volatile table
only for semi-permanent changes you want saved through a power
cycle.

Advertising
This manual is related to the following products: