Husqvarna 322E - Manual (Page 15)

English –
15
START AND STOP
Control before starting
!
Cold engine
IGNITION: Set the stop switch
to the start position.
CHOKE: Set the choke control
in the choke position.
AIR PURGE:
Press the air purge diaphragm
repeatedly until fuel begins to
fill the diaphragm. The
diaphragm need not be
completely filled.
Warm engine
Use the same starting
procedure as for the cold
engine, but do not set the
choke control in the choke
position. The start throttle
position is obtained by setting
the choke lever in the choke
position and then returning it
to its original position.
Stop
The engine is stopped by
switching off the ignition.
WARNING!
When the engine is started with the choke
lever in either the choke- or start throttle
position the cutting equipment starts to rotate
immediately.
!
Start
Press the machine body
against the ground using your
left hand (NOTE! Not your
foot). Grip the starter handle,
slowly pull out the cord with
your right hand until you feel
some resistance (the starter
pawls grip), now quickly and
powerfully pull the cord.
Reset the choke control as
soon as the engine fires and
repeat until the engine starts.
When the engine starts quickly
apply full throttle and the start
throttle will automatically
disengage.
NOTE! Do not pull the starter
cord out completely and do not
release the starter cord from
the fully extended position.
This can damage the machine.
For reasons of safety follow
these recommendations!
• Check that the support flange
is not cracked due to fatigue
or due to being tightened too
much. Discard the support
flange if it is cracked.
• Ensure that the nut has not
lost its tightening capacity.
The nut lock shall have a
locking torque of at least l.5
Nm. The nut’s tightening
torque shall be 35-50 Nm.
• Check that the blade and
blade guard are not damaged
or cracked. Replace the
blade or blade guard if it has
been exposed to impact or if
it is cracked.
Start and stop
WARNING !
The complete clutch cover with shaft must be
fitted before the machine is started, otherwise
the clutch can become loose and cause
personal injury.
Always move the machine from the filling
position before starting. Place the machine on
a flat surface. Make sure the blade cannot
come into contact with any object. Make sure
that no unauthorised persons are in the
working area, otherwise there is a risk of
serious personal injury. The safety distance is
15 metres.