Quick start, Figure 2-1 overall wiring schematic, 2 quick start – Honeywell ISM BAND XYR 5000 LINE User Manual

Page 10

Advertising
background image

2 Quick

Start

This section summarizes what must be done in order to get the device installed,
configured and in operation quickly. Additional detailed information is found throughout
this guide. Steps 1-3 refer to the following diagram:

Figure 2-1 Overall Wiring Schematic

1.

Wire 24VDC power to the Base Radio using the power terminals on either the
WMT or the Modbus connection. Do not apply power to both sets of terminals.

2.

Wire WMT RS-485 communications to the left terminal of the Base Radio.

3.

Wire Modbus RS-485 communications to the right terminal of the Base Radio.

4.

Place the terminating resistor between terminals A and B if the Base Radio will
be used as an End Unit (See Section 3.2.7).

3

Advertising