Honeywell ISM BAND XYR 5000 LINE - Manual (Page 3)

Base Radio
Models: WBR-AK
Versions 1.70 or later
Important Information for the User
• Changes or modifications not expressly approved by the manufacturer may void the
user’s authority to operate the equipment.
• This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1 This device may not cause harmful interference.
2 This device must accept any interference received, including
interference that may cause undesired operation .
• This device is for mobile and fixed use only (not portable or body-worn). A
separation distance of 20cm must be maintained at all times between the antenna
and the body of the user and bodies of nearby persons.
• If the WMT (RF Server) software is shutdown, the RS-485 network MUST be
physically disconnected from the PC as the serial port is no longer being controlled
by the software and may disrupt communications between multiple Base Radios.
• This device has been designed to operate with an antenna having a maximum gain
of 9 dBd. Antenna having a higher gain is strictly prohibited per regulations of
Industry Canada. The required antenna impedance is 50 ohms.
• To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the EIRP (Equivalent Isotropically Radiated Power) is not
more than that required for successful communication.
• The installer of this radio equipment must ensure that the antenna is located or
pointed such that it does not emit RF field in excess of Health Canada limits for the
general population; consult Safety Code 6, obtainable from Health Canada’s website
www.hc-sc.gc.ca/rpb .
FCC Certification
• This product is a frequency hopping RF transceiver module for the 900 MHz ISM
band, designed to meet FCC 15.247, and is used in industrial control and monitoring
applications.
The antenna is factory installed and MUST NOT be removed or modified by user. •
This document cannot be changed without prior FM approval
Copyright 2006 by Honeywell International Inc.
Rev. 4- 08/30/2006
While this information is presented in good faith and believed to be accurate, Honeywell disclaims the implied warranties of merchantability and fitness for a
particular purpose and makes no express warranties except as may be stated in its written agreement with and for its customers.
In no event is Honeywell liable to anyone for any indirect, special or consequential damages. The information and specifications in this document are subject to
change without notice.
Honeywell ® and TotalPlant ® are U.S. registered trademarks Of Honeywell International Inc.
Other brand or product names are trademarks of their respective owners.
Honeywell Inc.
Industrial Measurement and Control
2500 West Union Hills Drive
Phoenix, AZ 85027
III