Husqvarna Grass Catcher 2345 XLS - Manual (Page 12)

13
• If the grass catcher fails to pick up cut grass
or leaves, it is an indication that clogging has
occurred in the system or that the grass catcher
containers are full.
a. Disengage blades, place motion control levers
in neutral position.
- Unlatch and raise cover.
- Slide out containers and dispose of
clippings.
- Replace containers, close cover, and
latch.
b. Unlatch chutes and check for clogging.
- Remove all debris in chute.
- Reassemble and latch chutes.
OPERATION
CAUTION
• DO NOT operate mower with
grass catcher partially installed.
• Disengage blades and stop
engine before leaving mower seat
to empty containers, unclogging
chutes, etc.
• Close cover before starting.
• Disengage mower blades when
crossing driveways or gravel
surfaces and other areas where
thrown objects could be a hazard.
• DO NOT attempt to vacuum cans
or other potentially hazardous
projectiles.
GENERAL RECOMMENDATIONS
Always observe safety rules when performing any
maintenance.
• Before each use check for loose fasteners.
• Clean unit thoroughly after each use.
BLADE CARE
For best results mower blades must be kept sharp.
Replace bent or damaged blades.
• See BLADE CARE instructions in your mower
operator’s manual.
STORAGE
When grass catcher is to be stored for a period
of time, clean it thoroughly, remove all dirt, grass,
leaves, etc. Store in a clean, dry place.
CAUTION
Do not leave grass in bagger
containers. Empty containers after
each use and before storing. Failure
to do so may result in spontaneous
combustion which could develop into
a fire.
CAUTION
Grass catcher components are
subject to wear, damage and
deterioration, which could expose
moving parts or allow objects
to be thrown. Frequently check
components and replace with
manufacturer’s recommended parts,
when necessary.
CAUTION
BEFORE PERFORMING
MAINTENANCE, SERVICE OR
ADJUSTMENTS:
• Set parking brake.
• Place motion control levers in
“NEUTRAL” position.
• Place clutch control in
“DISENGAGED” position.
• Turn ignition key to “OFF”
position.
• Make sure blades and all moving
parts have completely stopped.
• Disconnect spark plug wire(s)
from spark plug(s) and place wire
where it cannot come in contact
with plug.