Heat & Glo Fireplace HEAT-N-GLO FB-IN - Manual (Page 21)

21
Step 7. Installing Logs and Ember Material
Positioning the Logs
The logs have been packaged separately. Refer to the
installation instructions that accompany this manual. Save
the log instructions with this manual.
If sooting occurs, the logs might need to be repositioned
slightly to avoid excessive flame impingement.
Placing the Ember Material
Two separate bags of ember material are shipped with this
gas appliance. The bag labeled Glowing Ember (050-721)
is standard glowing ember material. To place the ember
material:
• Remove the glass door from the unit (see Figure 12).
Figure 12. Glass Assembly
• Place a dime size piece of GLOWING EMBER mate-
rial near port holes in burner top, sides and front (see
Figure 13).
• Space dime size ember pieces about a 1/2 inch apart.
Never press embers into burner ports. Do not cover burner
ports. Place dime size pieces around front and sides of
burner pan.
• Save the remaining ember materials for use during fire-
place servicing. The embers provided are sufficient for 2
to 4 applications.
• Place MYSTIC EMBERS over burner surface and around
base of the burner, do not cover any burner port holes.
Can be used on floor of firebox for a realistic ash-bed.
• Replace the glass door on the fireplace.
• Re-install and latch the decorative front.
Figure 13. Placement of the Ember Material
Combustible materials MUST
NEVER overlap onto the front
face.
1. Find the coiled low voltage wires
and ON/OFF switch attached to
outer right side of the insert (see
Figure 14).
2. Disconnect the ON/OFF switch
from the low voltage wire leads,
and insert the ON/OFF switch
through the hole at the upper
right corner of the surround - it
will be retained in the hole.
Step 8. Installing Trim
Surrounds
Figure 14.
SURROUND
WITH TRIM
FIREBOX
ON/OFF
SWITCH
LOCATING SLOTS
LOCATING TABS
PULL AND RELEASE
CLIPS TO OPEN
EMBER MATERIAL
(TOP SURFACE,
AND FRONT)
BURNER PAN
___________________________________________
___________________________________________
Shutter Settings
Burner NG LP
CFX-GRAND-B, FB-GRAND 3/8” Set
CFX-IN-B, FB-IN 1/2” Set