Motorised system, Gb41 – Humax VA-FOX User Manual

Page 43

Advertising
background image

Motorised System

GB41

6.

To set the East Limit:

a) Select Movement and use the buttons to move your

motor East or West until the motor is at the position you wish
to use as your East Limit. Use the buttons to stop the
motor at the correct position.

b) Highlight the Store East Limit option and press the

OK

button

to store the current position as your East Limit.

To set the West Limit:

a) Select Movement and use the buttons to move your

motor East or West until the motor is at the position you wish to use as your West Limit.
Use the buttons to stop the motor at the correct position.

b) Highlight the Store West Limit option and press the

OK

button to store the current position as your

West Limit.

The purpose of this is to set the motor position for each satellite manually.
This is useful if the satellite you require is not available from the pre-programmed list(see 3 above).
To do this, you must access the Satellite Settings menu. Do as follows ;

1. Select Service Searching from the main menu and press the

OK

button, to display the Service

Searching menu.

2. Select the Manual Search option and press the

OK

button, to display the Manual Search menu.

Select the relevant Antenna Alternative that you are using for this satellite.

3. Enter the Frequency, Polarisation, Symbol Rate and FEC of a transponder on the satellite you wish

to find. This transponder information should be unique to this satellite.

4. Select the Antenna Alternative option and press the

OK

button, to display the Satellite Settings

menu.

5. Highlight the option DiSEqC Command Mode and using the buttons change this to Installer.
6. Highlight the option Satellite name and use the buttons to select the satellite you want to find,

use others if the name of the satellite you want does not appear.

7. When you have selected the satellite you wish to find, go down to the Movement option and again

using the buttons to start the motor moving.

8. You should move the motor as far west as possible and the move it east so that you cover the

complete movement range of the motor.

9. During the move from west to east the Signal Quality bar should register a signal once.

This is the position of the satellite. If there are two or more different positions which registers a

signal, then you must choose another frequency that is unique to the satellite you want.

10. Use the Signal level and Strength Quality bar at the bottom of the screen to judge the best

position of the dish.

11. Use the buttons to stop the motor when required.
12. When you have the best position of the dish go to the Motor Control option and using the

buttons select store and press the

OK

button. The position of the satellite should now be stored.

13. If you do not store this position, it will be lost when you exit the menu.
14. Repeat the process for each satellite if required, remembering to use a different antenna

alternative for each satellite.

5. Manual Satellite Search

English (HSMM30GB) 10/30/02 10:06 AM Page 44

Advertising
This manual is related to the following products: