Hach sc1000 User Manual
Sc1000 controller
Advertising
Table of contents
Document Outline
- Section 1 Specifications
- Section 2 General Information
- Section 3 Installation
- 3.1 Mechanical installation
- 3.2 Mounting the controller
- 3.3 Wiring safety information
- 3.4 Electrical installation
- 3.5 DIN rail expansion modules
- 3.6 Expansion cards
- 3.7 Install an sc1000 network (sc1000 bus connection)
- 3.8 Connect probes to the sc1000 controller
- 3.9 Service port connection (LAN connection)
- 3.10 GSM modem connection
- 3.11 Storage card (SD card)
- Section 4 System Start Up
- Section 5 Standard Operations
- 5.1 The display module
- 5.2 The measured value display
- 5.3 The Graph display
- 5.4 The Main menu display
- 5.5 The alphanumeric keypad
- 5.6 Calibrate the touch screen
- 5.7 Specify the displayed language
- 5.8 Set the time and date
- 5.9 Set up system security (passcode protection)
- 5.10 Add and remove favorites
- 5.11 Add new components
- 5.12 Configure the network modules (Profibus/Modbus cards)
- 5.13 Remote control
- 5.14 Log data
- 5.15 Formula editor for output and relay card
- Section 6 Advanced Operations
- 6.1 Sensor status menu
- 6.2 Sensor setup menu
- 6.3 System setup menu
- 6.3.1 Output setup menu
- 6.3.2 Current inputs menu
- 6.3.3 Relay menu
- 6.3.3.1 General relay settings (available in all relay working modes)
- 6.3.3.2 Function set to ALARM working mode
- 6.3.3.3 Function set to FEEDER CONTROL working mode
- 6.3.3.4 Function set to 2 POINT CONTROL working mode
- 6.3.3.5 Function set to WARNING working mode
- 6.3.3.6 Function set to PWM CONTROL/LINEAR working mode
- 6.3.3.7 Function set to PWM CONTROL/PID CONTROL working mode
- 6.3.3.8 Function set to FREQ. Control / Linear working mode
- 6.3.3.9 Function set to FREQ. Control/PID CONTROL mode
- 6.3.3.10 Function set to TIMER working mode
- 6.3.3.11 Function set to SYSTEM ERROR working mode
- 6.3.4 Network Modules (Profibus, Modbus)
- 6.3.5 GSM module
- 6.3.6 Device management
- 6.3.7 Display settings
- 6.3.8 Browser access
- 6.3.9 Storage card
- 6.3.10 Security setup
- 6.4 Test/Maint Menu
- Section 7 Maintenance
- Section 8 Troubleshooting
- Section 9 Replacement Parts and Accessories
- Section 10 Contact Information
- Section 11 Certification
- Appendix A DIN Rail Expansion Modules