Honeywell GNS-XL - Manual (Page 249)

System Operation
3-131 GNS-X L Flight Management System
Rev. 0
Oct/96
6. Enter the desired route spacing in nautical miles. 60NM is nor-
mal.
7. ENT Key - DEPRESS.
8. Enter the expected ground speed in knots. A value of 100 to 999
Kts may be entered.
9. ENT Key - DEPRESS.
10. Enter the starting waypoint of the active flight plan leg for which
FDE prediction is being calculated. Pressing the BACK Key will
cycle through the waypoints on the active flight plan. Dashes are
displayed prior to the last waypoint on the flight plan. Pressing
ENT while the dashes are displayed will clear the start and end
waypoints, resulting in an undefined Oceanic/Remote segment.
11. ENT Key - DEPRESS.
12. Enter the ending waypoint of the active flight plan leg for which
FDE prediction is being calculated. The BACK and dashes oper-
ate the same here as in the previous step.
13. ENT Key - DEPRESS.
14. If no satellites are to be excluded from the FDE prediction,
DEPRESS the lower right Line Select Key and proceed to Step
20. If specific satellites are to be excluded from the FDE predic-
tion, go to Step 15.
15. ENT Key - DEPRESS to display the FDE EXCLUDE SATS 1/1
Page. See Figure 3-208
16. Line Select Key -
DEPRESS to position
the cursor in the SAT #
field.
17. Enter the satellite num-
ber to be excluded.
18. ENT Key - DEPRESS.
The satellite number is now
displayed in the EXCLUDED
SATS LIST field.
EXCLUDED SATS LIST
SAT #--
OK? ENTER
FDE EXCLUDE SATS 1/1
<
<
Figure 3-208