Using the ultrakey lite controller 2, Logging onto the controller, Using the ultrakey lite controller – Honeywell ULTRAKEY LITE HJC5000 User Manual
Page 21: Chapter 2
Document 800-07422 Rev A
21
08/10
2
Using the UltraKey Lite Controller
You may need to learn how to use the UltraKey Lite both before and after you begin
configuring. In this section:
•
•
Using the UltraKey Lite to Navigate the LCD Menus
•
•
Note
Key availability is dependent on the mode selected. Functions only used with
the Standalone Mode (for PTZ/DVR functions) are not described in this
document and will be included in future releases.
Logging Onto the Controller
1.
Connect the keyboard with a power adapter (12V (±10%) DC/1 A included) or a
network cable with PoE.
2.
To configure the main menu settings, press Alt > Clr.
3.
Enter the PIN password 3434.
Note
If an invalid password is entered, a message displays and the controller
buzzes. Repeat the steps to log on.
When you are in the Password menu, press Alt > Clr again to exit the
Password menu.