Honeywell ULTRAKEY LITE HJC5000 - Manual (Page 39)

UltraKey Lite Controller Installation and User Guide
Document 800-07422 Rev A 39
08/10
5. Press the LCD up/down arrow keys to scroll through the options (serial port, network,
language, back light, slider update, cascade linkage, hardware test, about).
6. Scroll to the Configuration: Network menu, then press
Ent.
7. There are three sub-menus in this menu (Show Net Infor,
DHCP, and Manual Settings). The structure is as follows:
Show Net Infor Menu
The Show Net Infor Menu displays the Network information, including IP Address, DNS,
Gateway, and Netmask.
Automatically Configuring the Network Using DHCP
The Dynamic Host Configuration Protocol (DHCP) is a computer networking protocol used
by devices (DHCP clients) to obtain configuration information for operation in an Internet
Protocol network. It is used to configure the network automatically.
Automatically configuring the network using the DHCP menu:
1. Press the LCD down arrow to scroll to the Network: DHCP
menu.
2. Press Ent and the keyboard's network will be configured
automatically.
• If the network configuration is successfull, then a
Succeeded! message displays.
• If the network configuration was not successful, then a
Failed! message displays.
When the nework configures successfully, the user can enter the
Show Net Infor menu to see the IP Address, IP Address, DNS,
Gateway and Netmask.
Manually Configuring the Network
Manually configuring the network using the Manual Setting menu:
1. Press the LCD down arrow key to scroll to the Network: Manual Setting menu
Configuration
Network
Network
Show Net Infor DHCP Manual Setting
Network:
DHCP
Network:
Show Net Infor
Network:
Manual Setting
Network:
DHCP
Please wait....
Succeeded!
Failed!
Network:
Manual Setting