haier HLC22E - Manual (Page 21)

Menu Operations
Setup Menu Options
1. Press MENU button and CH+/CH- until the following menu appears on the
screen.
2. Press VOL+/OK button to enter the Setup menu and CH+/CH- to go up and
down to select the desired option .
3.Press VOL+/OK button to confirm and VOL+/VOL- increase and decrease
the level to adjust the selected option to your preference .
4. Repeat step 2 and step 3 until desired quality has been achieved .
Picture
Audio
Setup
Feature
Tuning Band
DTV Signal
Auto Ch Search
Add On Ch Search
Manual Ch Set
Channel Label
Menu Language
Reset
Air
Move /OK Select /Exit/Menu Exit
Function:
Tuning Band: Press VOL+/OK button to select Cable Auto, Air, Cable,
Cable HRC, Cable IRC.
DTV Signal:
Auto Ch Search: Press CH+/CH- button to select the item. Then press VOL+/
OK button to enter your selection and scan. All channels now available will be
automatically preset in order .After the search has finished, the first program
number will display on the screen. This search automatically adds only the
active channels in your area to the TV's memory. It deletes any channels on
which there is no broadcast or a poor signal. The channels found are
automatically saved as below:
Shows the signal strength of the reception.
Auto program Menu
NTSC Channel 19
Analog Channels Found
Digital Channels Found
Progress(%) Not Found
2
0
12
Exit/Menu Stop
Note: The TV searches channels in analog first and then searches channels in
digital signal ,
which may take up to few minutes.