HONDA Outboard Motor BF135A - Manual (Page 44)

42
Top-Mount Type
OPERATION
EMERGENCY STOP
SWITCH
SWITCH CLIP LANYARD
TAKING CARE OF
UNEXPECTED PROBLEMS
If the engine is not properly
warmed-up bef ore raising the engine
speed, the buzzer and overheat
indicator may activate, and the
engine speed will be automatically
reduced.
The engine will not start or run,
unless the clip is in the switch.
The emergency stop switch clip
and lanyard system is a safety
device that will stop the engine if
you fall away from the controls
while operating the boat.
Always attach the lanyard to your
PFD, or to your wrist, before
starting the engine.
Put the switch clip in the
emergency stop switch, and attach
the lanyard to your PFD (Personal
Flotation Device) or to your wrist,
as shown.
During the warm-up period, check
the oil pressure indicator (p.
),
overheat indicator (p. ), and
cooling system indicator (p. ).
If the indicators show any
abnormal condition, immediately
stop the engine and determine the
cause of the problem. Refer to
from p. .
If the fast idle control was used to
warm up the engine, gradually
return the control lever to the N
(neutral) position as the engine
warms up.
1.
5.
29
30
29
85
04/01/21 11:14:34 31ZY6600_043