HONDA HS520A - Manual (Page 6)

6
4. Install the discharge chute using the three 6 mm Phillips-head
screws and 6 mm self-locking nuts. Make sure the screws go on
the inside and the nuts on the outside. Tighten the nuts securely:
HEX NUT TORQUE: 7 ft-lbs (10 N•m)
5. Lift the spark plug door and
attach the spark plug wire
to the spark plug.
6. Remove any packing material from the side of the snowthrower.
ADD OIL & FUEL
1. The snowthrower is shipped
WITHOUT OIL in the engine.
2. Add enough of the recommended
oil (page 10) to bring the oil level
to the top of the filler hole. A bottle
of oil is included in the box with
your snowthrower.
All Honda engines are run at the
factory prior to packaging. Most of
the oil is removed prior to ship-
ment; however, some oil remains
in the engine. The amount of oil left in the engine varies.
3. Add regular unleaded fuel to the fuel tank. The fuel capacity is
1.37 US quarts (1.3 liters). See page 12.
BEFORE USE
All operators of the snowthrower must read the following chapters
before using the snowthrower:
SNOWTHROWER SAFETY (page 2)
CONTROLS (page 4)
BEFORE OPERATION (page 7)
PHILLIPS-HEAD
SCREW (3)
6 mm NUT (3)
PHILLIPS-HEAD
SCREW (3)
6 mm NUT (3)
CHUTE BASE
CHUTE
CORRECTLY
ASSEMBLED
UPPER LIMIT