Harbor Freight Tools 66950 - Manual (Page 5)

SKU 66950 For technical questions, please call 1-800-444-3353. Page 5
Rear Grill. WArNING! Do not acti-
vate Fan until properly latched.
Use Screws (24) to fasten Front and
8.
Rear Shaft Housing (23, 25) to Upper
Shaft. See Figure B.
OperATION
read eNTIre ruLeS FOr
SAFe OperATION section at
beginning of manual including
all text under subheadings
therein before set up or use.
To make the fan oscillate, push the 1.
Knob (11) down. To make the fan
stop oscillating, pull the Knob up.
To adjust the angle of air flow, tilt the
2.
Housing (12) and move to desired
angle.
To adjust height of fan, loosen the
3.
Height Adjustment Knob (28) and
raise or lower fan. Retighten Knob
once desired height is reached.
To activate, plug the Power Cord (36)
4.
into the nearest wall outlet.
To adjust the speed, push one of the
5.
desired Switches (21). The available
speeds are Low, Medium and High.
To turn off fan, press the Off Switch.
INSpeCTION AND MAINTeNANCe
TO preVeNT
SerIOuS INjurY
FrOM ACCIDeNTAL
OperATION Or eLeCTrIC
SHOCk: Before appliance
inspection or maintenance,
make sure Off key is pressed
and power Cord is unplugged.
TO preVeNT SerIOuS
INjurY FrOM AppLIANCe
FAILure: Do not use
damaged appliances. If
abnormal noise or vibration
occurs, have the problem
corrected before further use.
BeFOre eACH uSe, 1. inspect con-
dition of the Fan. Check for loose
screws, misalignment or binding of
moving parts, cracked or broken
parts, and any other condition that
may affect its safe operation.
Clean regularly to prevent dust from
2.
accumulating on Propeller (4). Un-
fasten latches along Front and Rear
Grills, remove Front Gill, and use
damp cloth to wipe Blade. Dry and
replace Front Grill before use.
To maximize air circulation, dismantle
3.
Grills and Propeller and wash and dry
each part when dirty.
WArNING!
4. Do not allow any water to
get into the Motor (8).
pLeASe reAD THe FOLLOWING CAreFuLLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLy DIAGRAM IN
THIS MANUAL AS A REFERENCE TOOL ONLy. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANy
REPRESENTATION OR WARRANTy OF ANy KIND TO THE BUyER THAT HE OR SHE IS qUALIFIED TO MAKE ANy REPAIRS
TO THE PRODUCT, OR THAT HE OR SHE IS qUALIFIED TO REPLACE ANy PARTS OF THE PRODUCT. IN FACT, THE
MANUFACTURER AND/OR DISTRIBUTOR ExPRESSLy STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN By CERTIFIED AND LICENSED TECHNICIANS, AND NOT By THE BUyER. THE BUyER ASSUMES ALL
RISK AND LIABILITy ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.