Setup failed – HP LaserJet 1320nw Wireless User Manual
Page 33
ENWW
Solving problems that occur during installation 27
1
Print a network configuration page.
To print a configuration page, when the printer is in the Ready state, press and hold the Go
button for 5 seconds. For more information, see
.
2
Enter either the URL or device IP address from the network configuration page into the
Address field on your Web browser. The EWS Home page appears, showing the printer
device information.
3
Click the Networking tab. The Network Settings page appears. The General tab is open.
4
Click the Wireless tab.
5
Scroll to the Authentication section, and click Advanced Configuration. The Wireless
Communication Mode page appears.
6
Select Infrastructure and click Next. The Wireless Network Name page appears.
7
Select a network name (SSID) from the list of detected networks, or enter the name of a new
wireless network.
8
Click Next. The Wireless Authentication page appears.
9
Select WPA/PSK, enter a Pass Phrase (from 8 to 63 characters in length, including spaces)
that will be used by the software to generate a pre-shared key.
Note
All devices on the network must use the same pass phrase.
10 Follow the onscreen instructions to configure the printer for the authentication and encryption
type selected.
11 When finished, click Next. The Configuration Review page appears.
12 Verify the information is accurate, and then click Finish.
Setup failed
Possible problem: No signal is being received by the device because it is not in range of the
access point (infrastructure) or computer (ad-hoc).
Move the printer and the computer closer together. If the distance between your computer and the
printer is significant, try reducing the distance. If possible, provide a clear path between the
computer and print server, and minimize sources of radio interference.
Possible problem: The setup program tried to change the computer’s wireless configuration so
that it can communicate to the printer, but was unable to reprogram the settings on the computer’s
wireless access card.
1
Quit all applications.
2
If your computer is connected to the Internet, disable the connection to your computer by
removing the Ethernet cable that connects the modem (cable, DSL, or dial-up) to your
computer.
3
Click Setup.
The Setup menu appears.
4
Select 6.
The Network menu appears.
5
Select 2.
The wireless radio setting options appear.
Note
The default setting for the wireless radio is Off.
6
Use the up and down buttons to select On.