Hamilton Beach 840043400 User Manual
Page 4
7
6
7
1. Turn temperature control dial to OFF. Push the STEAM or
DRY IRON/CLEAN switch to DRY IRON/CLEAN. Unplug
and let cool. The iron takes longer to cool down than it does
to heat up.
2. To empty water from iron, slowly tilt pointed end of iron
down over a sink. Water will run out of water tank opening.
3. Wrap cord loosely around iron and store iron in an upright
position. Do not store iron laying flat on soleplate.
CARING FOR YOUR IRON
FABRIC/SETTING CHART
Dr
y Iron
Steam R
ange
1
Setting
To Iron
Ironing Instructions
Acetate, Silk
Acrylic, Nylon
Polyester, Rayon
Dry iron on the wrong side of
the fabric.
For wool, use a press cloth and
steam iron on the wrong side.
2
3
4
Cotton Blends
5
Wool
6
Cotton
7
Linen
0
Off
Iron on wrong side of fabric
while still damp.
For polyester, dry iron while the
fabric is still damp.
Iron cottons while still damp,
using steam and/or spray.
CARING FOR THE SOLEPLATE
Dry iron using spray if necessary.
Iron using steam or spray for
difficult wrinkles.
1. Never iron over zippers, pins, metal rivets, or snaps, as
these may scratch the soleplate.
6
Automatic Shutoff Light
The light comes on when the iron is plugged
in, even if the temperature control dial is
set at Off. The light indicates the iron is
plugged in.
The iron will shut off and the light will go
out one hour after it is plugged in. When
the light goes out unplug the iron and
plug back in to reset.
Reversible Cord
Some irons have a reversible cord. The cord
can be moved from one side to the other, to
accommodate right- or left-handed users.
Unplug iron. Remove screw and back cover
as shown. Move cord as desired and
replace back cover and screw.
WARNING: To prevent risk of electrical shock
unplug iron before reversing cord.
Acetate
Silk, Acrylic
Nylon, Rayon
Polyester
Cotton Blends
Permanent Press
W
ash N' W
ear
W
ool Blends
Ramie
Flax
1 DELICA
2 LIGHT
3 EASY
CARE
4 WOOL
5 COTT
ON
6 LINEN
EL
EC
TR
ON
IC
S
HU
T-O
FF
M
EM
OR
Y
SP
RA
Y, B
LA
ST
, S
TE
AM
&
D
RY
RE
FIL
L
FU
LL
®
Wrap & Snap Cord
When finished ironing, let the iron cool then
wrap cord and secure with the Wrap & Snap
on the plug.
Swivel Cord
For irons with a swivel cord, rotate the cord
to the desired position for ironing.