HONDA RM752A - Manual (Page 5)

CHECK LISTS
PRE-DELIVERY CHECK LIST
Inspect the mower thoroughly after assembly to
ensure it is set up properly before delivering it to the
customer. The following check lists are a reminder
of points
to inspect. Check off each item as it is
found satisfactory or after proper adjustment is
made.
Check that all safety decals are installed and in
good condition.
Check that
and guards are properly
installed and in good condition.
Check all bolts to be sure they are correctly
torqued.
Check that all cotter pins are properly installed.
Lubricate all grease fittings; check to make
sure a small amount of grease comes out of
seal.
Check that blades have been properly
installed.
DELIVERY CHECK LIST
Inform customer to operate PTO at 2,000
maximum.
Check mower attitude and alignment.
Show customer how to make adjustments.
Explain importance of lubrication to customer
and point out lubrication points on mower.
Present the Operator's Manual, and ask
customer to familiar with all sections.
Explain to customer that when is trans-
ported on road or highway, safety devices.
should be used to give adequate warning to
operators of other vehicles.
DAILY CHECK LIST
Lubricate all grease fittings; check to make
sure a small amount of grease comes out of
seal.
Check that tractor PTO spring-activated
locking collar slides freely and is seated firmly
in mower driveline spline groove.
Check that both side skids, the left side shield
and either the discharge chute
or right side
shield are installed.
Make sure blades are sharp, free of nicks or
cracks and are securely fastened.
Make sure all hardware is securely fastened
and
in good condition.
Check that mower is properly and securely
attached
to tractor.
Check that all safety decals are installed and in
good condition.
Check that shields and guards are properly
installed and
in good condition.
GENERAL INFORMATION
The purpose of this manual is to assist you in
operating and maintaining your mower. Read it
carefully.
It furnishes information and instructions
that will help you achieve years of dependable
performance. These instructions have been
compiled from extensive field experience and
engineering data. Some information may be general
in nature due
to unknown and varying operating
conditions. However, through experience and these
instructions you should be able
to develop
procedures suitable to your particular situation.
The illustrations and data used in this manual were
current at the time of printing, but due to possible in-
line
production changes, your machine may vary
slightly in detail.
\
We reserve the right to redesign and change the
machines as mav be without notification.
Some lllustratlons In thls manual show the
mower wlth shields and guards removed to
provide
a better view. The mower should never
be operated wlth any or guards
removed.
Throughout this manual, references are made to
right and left directions. These are determined by
standing behind the equipment facing the direction
of forward travel.
Blade rotation is clockwise as viewed from the top
of the mower.
F-7756 (1 0-89) 3