Hampton Direct H25-NG1 - Manual (Page 31)

Hampton ® H25-1 Direct Vent Freestanding Gas Stove 31
A)
D) B)
C)
LOG SET INSTALLATION
1) Shut off the gas supply.
2) Lift off the Cast Top and remove the Glass Front (see manual).
3) Carefully remove the logs from the box and unwrap them. The logs
are fragile, handle with care - do not force into position.
4) Place the rear log on the 2 rear log locating pins on the rear of the
burner with the fl at side to the back.
Read the instructions below carefully and refer to the diagrams.
If the logs are broken do not use the unit until they are replaced.
Broken logs can interfere with the pilot operation.
The gas log kit contains the following:
a) Rear Log
b) Left Side Front Log
c) Right Side Front Log
d) Center Front Log
e) Embers 902-156
Left Front Log
Right Front Log
Tabs
NOTE: This is
a rear view.
Tabs
NOTE: This is
a rear view.
The Front Right Log
front edges should be
placed parallel against
the front edge of the
burner.
A)
B)
B)
C)
C)
C)
B)
A)
5) Place the 2 front logs on the front log locating pins. Ensure the back
of both logs rest against the tabs.
INSTALLATION