Heath Zenith Motion Sensing Diecast Metal Lantern 9600LED series - Manual

Dated receipt required for warranty replacement.
Features
• Automatically comes on when motion is detected.
• Automatically turns light off.
• Photocell keeps the light off during daylight
hours.
requirements
• The light control requires 120 volts AC.
• If you want to use Manual Override mode, the
control must be wired through a switch.
nOtiCe: Not to be used on light dimmer or timer-
controlled circuits.
• some electrical codes require installation by a
qualified electrician.
• This light fixture has been tested/certified us-
ing Lights of America LED Lamp Model No.
2025LEDE12.
unpaCking
Be sure to remove all contents from packaging and
verify all items are present before assembling this light
fixture. This package includes the following items:
• Lantern
• Three LED Lamps
(Lights of America Model: 2025LEDE12)
• Universal mounting bracket (X-Bar)
• Mounting hardware
• Wire nuts
• Owner’s Manual
© 2008 598-1338-03
motion sensing
Diecast metal Lantern
model: 9600LeD series
instaLLatiOn
For best performance, mount the fixture about 6 feet
(1.8 m) above the ground.
1. Remove two decorative nuts.
2. Remove X-Bar.
3. Tighten mounting screws on X-Bar finger tight.
4. Attach X-Bar to junction box.
Junction Box
X-Bar
Decorative Nut
Lantern Base
Lantern Mounting
Screw
X-Bar
Bracket Mounting
Screw
Note: We recommend having an assistant help hold
the lantern assembly during the wiring process.