Honeywell TE821WD - Manual (Page 23)

23
Note: The wind speed alert is set at 5 mph default and the wind gust alert is set to 7 mph default to prevent false alerts from
small fluctuations.
Configuring Wind Display
With the wind icon flashing, press the SET button to alternate between “wind chill with direction in bearings”, “wind chill with
direction in compass points”, “anemometer temperature & wind direction in compass points” or “anemometer temperature and
wind direction in bearings.”
Setting Wind Speed in km/h, mph, m/s or knots
With the wind icon flashing, press and hold the SET button to set the wind speed units in km/h, mph, m/s or knots.
Viewing Wind Statistics
With the wind icon flashing, press the MEMORY button to recall a current wind speed, a daily maximum wind speed with
“DAILY MAX” displayed, a gust speed with a “GUST” displayed and a daily maximum gust speed with a “GUST DAILY MAX”
displayed.
Resetting the Wind Statistics Memory
With the wind icon flashing, press and hold MEMORY button to reset all wind statistics.
Enabling or Disabling the Wind Alerts
With the wind icon flashing, press the ALARM/CHART button to recall a current wind speed, a wind speed alert with the
“ALARM HI” displayed or gust alert with the “GUST ALARM HI” displayed.
If the alert is disabled, “OFF” will be displayed; otherwise the alert value is shown.
When a wind alert is displayed, press UP or DOWN arrow button to activate or deactivate it.
Wind Alert programming
· With the wind icon flashing, press ALARM/CHART button to select the desired alarm.
· Press and hold ALARM/CHART button until alert and corresponding icon will flash.
· Set the alert using UP or DOWN arrow button. Press and hold either button for fast digits advance.