Hoover S3670 - Manual (Page 3)

3
Unpack cleaner from carton and iden-
tify the parts shown. Remove and
dispose of cardboard packing.
A. Canister cleaner with tools
B. WindTunnel™ powered nozzle
C. Extra paper bag (one bag is
installed in cleaner)
D. Telescopic wand and hose
E. Powered Hand Tool
F. Hard Floor Tool
A B
C
D 1-1
1. Assembling cleaner
This cleaner was inspected and packaged carefully before being shipped from the
factory. If you should happen to need assistance during assembly or operation, call
1-800-944-9200 for an automated referral of authorized service
outlet locations (U.S. only) OR
1-800-263-6376 to speak with a representative in our Consumer Response
Center Mon-Fri 8AM-7PM EST. OR
Visit us online at www.hoover.com to find the service outlet nearest you
(click on the “Service” button).
Carton contents
Connect hose, wands and nozzle
1-2
Connect hose
With hose toward rear of cleaner, push hose
connector into opening in bag lid.
Note: The flexible hose contains
electrical wires for connection to the
power nozzle and should not be used
if damaged. The wires should not be
seen through the outer skin.
Attach nozzle and wand
The wand with the storage clip connects to
the power nozzle.
Attach it to power nozzle by fitting button pro-
jection (B) on wand into nozzle connector (C)
opening. Be sure nozzle is locked in place.
To release, press down on wand release
pedal (D) and remove wand.
B
To attach the hose to the telescopic wand,
Push the hand grip (G) down onto wand so
that the locking latch of the release button (F)
locks the hand grip into place.
C
D
Continued ➟
B
1-3
G
1-4
F
E
F