Connecting the video source, Connecting the loop through video, Connecting audio – Honeywell HRSD4 User Manual
Page 24
Installation
24
Connecting the Video Source
Connect the coaxial cables from the video sources to the BNC Video In connectors.
Figure 2-2
Video Input Connectors
Connecting the Loop Through Video
If you would like to connect your video source to another device, you can use the Loop
BNC connectors.
Figure 2-3
Video Loop Through Connectors
Note
The Loop BNC connectors are auto terminated. Do NOT connect
a cable to the Loop BNC unless it is connected to another
terminated device because it will cause poor quality video.
Connecting Audio
Note
It is the user's responsibility to determine if local laws and
regulations permit recording audio.
Your DVR can record audio. Connect the audio source to Audio In as needed using an
RCA jack. Connect Audio Out to your amplifier.
Figure 2-4
Audio In and Out Connectors