Setting up the date and time – Honeywell HRSD4 User Manual
Page 41
Configuration
Document 800-00919
Rev F
41
02/08
3.
Select Start, and enter the Admin password to start the upgrade.
The system restarts automatically after completing the upgrade. The software
starts running after restarting the unit.
Note
You cannot upgrade the software during clip copy.
4.
Save your changes by highlighting OK and pressing
. Select Cancel to exit
the screen without saving the changes.
Setting up the Date and Time
Highlight Date/Time in the Main menu and press
. The Date/Time setup screen
appears.
Figure 3-10
Date/Time Setup Screen
Caution
If you set a date and time that is older than some of your recorded
images, then any images with dates and times later than the new
setting will be deleted.
Changing the Date
1.
Highlight the first field beside Date/Time in the Date/Time setup screen and press
. The individual sections of the date highlight.
2.
Adjust the date using the Up and Down arrows.
3.
Press
when you have the correct date.