Using the record mode setup screen – Honeywell HRSD4 User Manual

Page 62

Advertising
background image

Configuration

62

Your DVR offers a variety of flexible recording modes. You can set it to:

record all the time

record only events

continue recording after the hard disk drive is full by recording over the oldest
video

alert you and stop recording when the hard disk is full

Using the Record Mode Setup Screen

From the Main menu, select Record, then highlight Record Mode and press

. The

Record Mode Setup screen appears.

Figure 3-32

Record Mode Setup Screen

Table 3-8

Record Mode Setup Screen Options

Option

Function

Resolution

Highlight the field beside Resolution and press

.

Note

The maximum recording speed is 30 images per second (25 ips for PAL)
when the resolution is set to Standard. However, when set to High, the
recording speed decreases to 15 images per second (12.5 ips for PAL).

End Of Disk

Highlight the field beside End Of Disk and press

to toggle between Stop and Overwrite.

When in the Stop mode, the DVR stops recording
when the hard disk drive is full. When in the Overwrite
mode, the DVR continues recording when the hard
disk drive is full by overwriting the oldest video.

If the DVR is set to the Stop mode, you can set it to
beep or to activate the Alarm Out port when the hard
disk drive is full.

On Disk Full Beep

Highlight the field beside On Disk Full Beep and press

to toggle between On and Off.

Advertising