Setting up dvr passwords – Honeywell HRSD4 User Manual
Page 94
Configuration
94
Figure 3-58
Callback Center (Modem) Setup Screen
1.
Highlight the field beside Pager Number and enter the telephone number of the
pager. Enter the number as it must be dialed from your telephone system. For
example, if you must dial 9 for an outside line, enter 9 before the pager number.
2.
Highlight the field beside Mailbox and use the virtual keyboard to enter the voice
mailbox number if your pager uses a voice mailbox.
3.
Highlight the field beside Site ID and use the virtual keyboard to enter a three-digit
site ID number.
Note
The DVR waits for at least four minutes between pages. If
another event occurs less than four minutes after the DVR has
notified a pager, it does not dial the pager again. The DVR is
programmed this way so that the telephone line does not get
tied up.
4.
Save your changes by highlighting OK and pressing
. Select Cancel to exit
the screen without saving the changes.
Setting Up DVR Passwords
An Administrator password is required for the following actions:
•
to turn off the system
•
to enter the setup screen
•
to load default setups
•
to clear all data
•
to change system date and time
•
to change the Administrator password