HONDA WSP33AA - Manual (Page 10)

8
IMPORTANT INSTRUCTIONS BEFORE INSTALLATION
Failure to follow these instructions may cause serious bodily injury and/or property damage.
• Pumps are 115 V, 60 Hz and are grounded to prevent electrical shock.
WARNING: Risk of electric shock—this pump is supplied with a grounding
conductor and grounding-type attachment plug. To reduce the risk of electric
shock, be certain that it is connected only to a properly grounded, grounding-
type receptacle.
• Use a separate 15 amp circuit breaker or 15 amp fuse block with the pump.
• Do not use an extension cord with the pump.
• Do not cut off the ground pin or use an adapter fitting.
• Do not work on the pump or switch until any or all power cords are
unplugged.
Electrical information
1. Before installing or servicing your pump, BE CERTAIN pump power source
is disconnected.
2. Installation and electrical wiring must adhere to state and local codes and
must be complete before priming pump. Check appropriate community
agencies, or contact local electrical and pump professionals.
3. CALL AN ELECTRICIAN WHEN IN DOUBT. Pump should be connected to
a separate 15 amp circuit breaker or 15 amp fuse block. Plugging into existing
outlets may cause low voltage at motor, causing blown fuses, tripping of
motor overload, or burned out motor.
4. Do not connect pump to a power supply until permanently grounded. For max-
imum safety, ground pump to a circuit equipped with a fault interrupter device.
5. Voltage of power supply must match the voltage of the pump.
6. Before installing pump, clear sump basin of any water, debris, or sediment.
WARNING: Sump basin must be vented in accordance with local
plumbing codes. Honda WSP pumps are not designed for and CAN
NOT be installed in locations classified as hazardous in the National
Electric Code, ANSI/NFPA 70.
7. The sump basin should be between 18" and 24" in diameter and made of
plastic, fiberglass, or concrete.
8. The following may cause severe damage to pump and will void warranty:
• Using an extension cord.
• Cutting off the ground pin or using an adapted fitting.
• Working on pump or switch while plugged in.
• Removing motor housing, unscrewing impeller, or otherwise removing
impeller seal.
0204 HONDA WSP manual.qxd 3/24/2004 2:14 PM Page 10