HONDA FS5047 - Manual (Page 14)

Set broom in transport position. Stop tractor
engine, set parking brake and remove ignition
key.
Set broom storage stands in most extended
position so that stands extends the broom
bristles.
Remove hair pin (fig.1, item 1) from welded
sleeve on right hand side of broom mounting
bracket. Set pin (fig.1, item 2) in the
in most position (you may have to slightly
raise broom head) and lock in place with
hair pin.
IMPORTANT: Once the broom is fully remounted,
this pin has to be set in its most extended
position in order to allow the broom to follow
ground variations.
d) Carefully lower broom so it rest on the
storage stands.
e) Disconnect broom driveline from tractor PTO
shaft and place driveline on its support
located on female hitch.
f) Remove linchpin from quick hitch latch.
Place male hitch lever. rearward in "unlocked"
position.
g) Carefully back tractor away from broom.
OM 0180 13
FIGURE 1