Humminbird 531655-1_A - Manual

1100 Series™ In-Dash Mounting Kit
1
531655-1_A
Thank You
Thank you for choosing Humminbird®, America's #1 name in fishfinders. Humminbird® has built its
reputation by designing and manufacturing top-quality, thoroughly reliable marine equipment.
Genuine Humminbird® accessories offer the opportunity to upgrade and expand the capabilities
of your Humminbird® product.
Your Humminbird® is designed for trouble-free use in even the harshest marine environment. In
the unlikely event that your Humminbird® does require repairs, we offer an exclusive Service
Policy - free of charge during the first year after purchase, and available at a reasonable rate after
the one-year period. For complete details, see the Warranty section included in this manual.
Contact our Customer Resource Center at either 1-800-633-1468 or visit our website at
www.humminbird.com.
Installation Overview
Following are instructions for the installation of this accessory. Before you start installation, we
encourage you to read these instructions carefully in order to get the full benefit from your
Humminbird® accessory.
If you find that any items are missing from your installation kit, call our Customer Resource Center
at 1-800-633-1468 or visit our website at www.humminbird.com.
Installation
Start by placing the components on the surfaces where you intend to install them before
installation. Make sure that the surfaces you have chosen provide adequate protection from
wave shock, and that all cables can reach the control head.
NOTE: If a cable is too short for your application, extension cables are available.
Call Humminbird® Customer Support at 1-800-633-1468 for more information.
Parts and tools specific to In-dash mounting are:
• Threaded rods and hardware
• In-dash mounting foam pads
• In-dash mounting template
• Reciprocating saw for cutting dash material
• Masking tape to hold mounting template in place.
1. Locate a suitable, flat area of the dash to mount the control head. The control head
requires a depth of at least 4 inches (102 mm).
2. Tape the paper In-Dash Mounting template to the desired in-dash mounting location.
3. At a location inside the dotted line on the template, drill a hole large enough to insert
blade of reciprocating saw. In addition, drill the 4 mounting hole locations using a 3/16"
drill bit. Carefully begin cutting toward the dotted line, then follow the dotted line
around the template. Remove the template when finished.
4. Insert and tighten the four threaded rods into the four threaded inserts located on the
back side of the control head. Peel off the adhesive-backed foam pads and place them
on the back of the control head; make sure you notice the difference between the
longer top/bottom and shorter side pads.
© 2008 Humminbird®, Eufaula AL, USA.
All rights reserved.
Threaded Rod
Washer
Wing Nut
Lock Washer
Cut
Away
Dash
Foam Pads
Foam Pads
Mounting the Control Head