High End Systems Technobeam User Manual
User manual
Advertising
Table of contents
Document Outline
- User Manual
- Table of Contents
- Introduction
- Chapter 1 Preparing to Install Your Fixture
- Specifications
- Model Numbers
- Dimensions (with yoke and handles)
- Weight (including yoke)
- Electrical Specifications
- Technobeam Laser Aiming Device™ (LAD™)
- Important Power Cord Information - U.K. Only
- Dichroic, Litho and Effects Specifications
- Safety Standards
- Electromagnetic Standards
- Environmental Specifications
- DMX Data Cabling
- Controllers
- Optional Accessories
- Unpacking the Fixture
- Installing the Power Cord Cap
- Installing the Yoke
- Setting the Fixture Voltage
- Setting the Beam Angle
- Specifications
- Chapter 2 Setting Up Your Fixture
- Chapter 3 Using the Menus
- Menu System Overview
- Menu Map
- Menu Options
- Address Menu (ADDR)
- Set Menu (SET)
- Mode Menu (MODE)
- Test Menu (TEST)
- Information Menu (INFO)
- Viewing the Logic Board Temperature (TEMP)
- Viewing the Current Lamp Hours (L/HR)
- Viewing the Current Fixture Hours (F/HR)
- Viewing the Number of Current Lamp Strikes (L/ST)
- Viewing the Current Software Version (VER)
- Viewing DMX Status and Construct Values (FIXT)
- Viewing DMX Data for Another Device (DATA)
- Viewing Sensor Information (SENS)
- Resetting Fixture Hours (F/RS)
- Resetting Lamp Hours (L/RS)
- Preset Menu (PRST)
- Chapter 4 Preset Programming
- Programming Overview
- Creating a Scene
- Orienting and Powering On the Fixture
- Turning on the Lamp
- Opening the Shutter
- Positioning the Mirror
- Focusing on a Litho
- Selecting Color Wheel Constructs
- Selecting a Color Wheel Pause Time
- Selecting Effects Constructs
- Refocusing the Fixture
- Setting a Delay Time
- Creating Scene 2
- Playing Back Both Scenes
- Synchronizing Preset Playback
- Capturing Presets
- Chapter 5 Using the Laser Aiming Device™ (LAD™)
- Chapter 6 Servicing Your Fixture
- Appendix A DMX Protocols
- Appendix B Factory-Installed Wheels
- Appendix C Important Safety Information