Harbor Freight Tools 47911 - Manual (Page 4)

3. WARNING: Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities, contain chemicals known (to the State of California)
to cause cancer, birth defects or other reproductive harm. Some examples of
these chemicals are: lead from lead-based paints, crystalline silica from bricks
and cement or other masonry products, arsenic and chromium from chemically
treated lumber. Your risk from these exposures varies, depending on how often
you do this type of work. To reduce your exposure to these chemicals: work in a
well ventilated area, and work with approved safety equipment, such as those
dust masks that are specially designed to filter out microscopic particles. (Cali-
fornia Health & Safety Code 25249.5, et seq.)
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on page 6 are
included. If any parts are missing or broken, please call Harbor Freight Tools at the num-
ber shown on the cover of this manual as soon as possible.
PRODUCT OVERVIEW
1. The Dust Collector Accessory Kit is designed for one and two power equipment
tool hook-ups, and is typically used for the collection of wood dust, wood chips,
sand, and other light debris. The Dust Collector Accessory Kit may be attached
to table saws, band saws, sanders, router tables, shapers, jointers, and variety of
dust collecting machines all having a 4” dust port. Due to the wide diversity of
power machinery to which the Dust Collector Kit may be attached, it is recom-
mended that only a qualified technician perform the assembly procedure.
SKU 47911 PAGE 4
ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed below, refer to the
AssemblyDiagram on page 6.
1. Though the Dust Collector Accessory Kit is designed to offer a wide variety of appli-
cations, the following illustration depicts a typical assembly method to hook-up one power
equipment tool and two power equipment tools. (See Figure A, next page.)
2. NOTE: The Dust Collector Accessory Kit is designed to be attached to stationary
power equipment tools and dust collectors having 4” diameter dust ports. De-
pending on the diameter of the dust port of your power equipment tools and dust
collector, it may be necessary to attach size adapters (not provided) to ensure a
proper fit.