General information, Front bumper and brush guard, T (figure 1) – Husqvarna FOREST AND GARDEN HUV4210-G User Manual
Page 14: N (figure 2, Warning
General Information
Page 12
2008 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual
ý
WARNING
• Use insulated tools when working near batteries or electrical connections. Use extreme
caution to avoid shorting of components or wiring.
All vehicles:
• Wear safety glasses or approved eye protection when servicing the vehicle or battery charger.
Wear a full face shield and rubber gloves when working on or near batteries.
• Do not wear loose clothing or jewelry such as rings, watches, chains, etc., when servicing the
vehicle or battery charger.
GENERAL INFORMATION
This manual features two models: the electric vehicle and the gasoline vehicle. Throughout this manual,
important features unique to each model are highlighted. We urge the owner/operator to read and understand
this manual, and to pay special attention to the features specific to his/her vehicle(s).
FRONT BUMPER AND BRUSH GUARD
The front bumper and brush guard are an important part of the vehicle’s design for correct weight distribution.
These parts are interchangeable, but one or the other must be installed at all times during vehicle operation
to achieve proper balance (Figure 3 and Figure 4). See following WARNING.
Figure 1 Gasoline Vehicle
Figure 2 IQ System Electric Vehicle - 12-Volt Battery
Configuration
(Viewed from passenger side of vehicle)
1. Remove negative battery cable.
2. Remove positive battery cable.
Connect battery cables in reverse order.
(Viewed from driver side of vehicle)
1. Place TOW/RUN Switch in TOW before disconnecting or
connecting battery cables.
2. Remove negative battery cable.
3. Remove positive battery cable.
Connect battery cables in reverse order.
1
2
(–)
(+)
1
2
3
4
3
2
1
(–)
(+)