Product literature, Storage, Preparation of engine for storage – Hustler Turf Super Mini Z 52 User Manual

Page 36: Preparation of batteries for storage, New season preparation

Advertising
background image

This section contains sources of additional literature

concerning your tractor. Literature should be ordered from
your Hustler dealer or direct from indicated source.

Parts Manuals

If you would like to order a Parts Manual for a particular

tractor, the Hustler part number for that manual is listed in
the following chart. Please contact your Hustler dealer to
order the manual.

PRODUCT LITERATURE

Parts

Model

Manual

List

Model

Number

P/N

Price

Hustler Mini Z

927228, 927236, 927251, 927244

927483, 297491, 927525

302612

$22.50

Super Mini Z

927269, 927285, 927277, 927533

302620

$22.50

Hustler Z

926881, 926915, 926923, 926931

375535

$22.50

926949, 926964, 926667, 926675

927111

Hustler Z XR7

927723, 927731, 927749, 927756,

927772, 927798, 927806, 927814

106567

$22.50

Super Z

926725, 926741, 926766, 926972

375543

$22.50

926980, 926998, 927038, 927046,

927053, 927061, 927558, 927566,

927467, 927624

Super Z XR7

927467, 927624, 927673, 927681,

927848, 927855, 927871, 927889,

927897, 927913, 927921, 927939,

927947, 927970, 927988, 927996,

928002, 928010, 928028, 928036,

928044, 928051, 928069

106575

$22.50

Super Z Diesel

927327, 927335, 927608, 927616

350702

$22.50

Hustler ATZ

927178, 927186

397505

$22.50

ATZ XR7

928226, 928234

107906

$22.50

When storing the unit at the the end of the mowing season, the following

steps should be taken to ensure readiness for the next mowing season.

1. Remove all grass, dirt, and trash from tractor and mower. Clean

tractor and mower and touch up all scrapes with Hustler spray paint.

2. Replace air filter element.
3. Check thoroughly for any worn or damaged parts that need

replacing and order them from your dealer.

4. Thoroughly lubricate machine, according to lubrication instructions.
5. Check hydraulic oil level. Add oil if necessary or change oil and

filter if not done in last 500 hours. Refer to Maintenance section.

6. Block tractor up so weight is off tires.

NOTE:

Do not deflate tires.

7. Perform separate engine and battery preparation as listed below.
8. Store tractor in a clean, dry place.

Preparation of engine for storage

When engine is to be unused for long periods, proceed as follows:

1. Run engine for a minimum of 15 minutes.
2. Drain oil from crankcase while engine is still warm.
3. Refill with fresh oil of proper viscosity.
4. Drain fuel tanks.
5. Remove and replace fuel filter.
6. Clean exterior surface of engine. Spread a light film of oil over any

exposed metal surfaces of engine that are subject to corrosion.

7. Check oil filler cap and fuel tank cap to make certain they are

securely in place.

Preparation of batteries for storage

When the machine is to be unused for long periods, it is best to

disconnect the batteries and remove them from the unit. At this time
perform the following battery maintenance:

1. Clean battery
2. Check the electrolyte level
3. Charge the battery, if necessary
4. Store battery in a cool, dry place (do not expose to freezing

temperatures)

5. Always keep the battery fully charged. (Especially important to

prevent battery damage when the temperature is below 32F.)

New season preparation

Before starting the tractor following post season storage, the following

servicing is required:

1. Clean tractor, removing trash and dirt accumulation.
2. Check engine oil, hydraulic oil and coolant levels.
3. Fill fuel tanks with fresh fuel. Bleed fuel system as outlined in

Maintenance section. Run machine at half speed for 5 minutes,
checking operation of steering control lever. Stop engine and check
for oil leaks, loose fittings and so forth.

WARNING: At start of new season always check that fresh
oil and coolant have been added to machine. If oil and
coolant are drained at season’s end and not replaced, engine
damage will result.

4. Tighten any bolts that have loosened and make sure all hair pins,

cotter pins and clevis pins are in place.

5. Install all safety shields and review safety precautions listed in this

manual.

6. Check and inflate tires to 8-10 psi (55-69

KP

a).

7. Install fully charged batteries and attach the battery cables.

STORAGE

35

600876_0706

Advertising
This manual is related to the following products: