Honeywell FUSION - Manual (Page 48)

FUSION DVR Digital Recording and Transmission System
5–4
5.3 MOTION, CONTINUED
6 Beep on Detect When motion is detected, an internal speaker on the
DVR sounds an alarm.
7 Full Screen Pop-Up When motion is detected, the camera is displayed full
screen.
8 Clear Clears all motion areas for the selected camera.
9 Post Alarm
(MOTION)
Record video after motion has stopped for a specified
period of time. This option will only work for camera
set to record using motion detection.
10 Post Alarm
(SENSOR)
Record video after a sensor event has ceased for a
specific period of time. This option will only work for
cameras set to record from a sensor.
11 Regular Interval
Recording
This option allows you to record a single frame every
few minutes or every few hours to show that the DVR
is still functioning even when motion is not taking
place. This option only works when Motion recording
or Sensor recording is selected.
5.3.1 CREATING A MOTION AREA
1. Place the mouse pointer at the upper
left hand corner of the designated
area, press and hold down the left
mouse button, drag the mouse. Let go
of the button when the Motion Area is
of the desired size.
2. Continue creating as many Motion
Areas as desired (up to 5).
Resize and move motion areas by
dragging the sides and corners of the
Motion Area window.
5.3.2 REMOVING A MOTION AREA
To remove the motion areas, press .