haier AB422BCBAA - Manual (Page 10)

AUTO COOLING DEHUMIDIFYING HEATING FAN
AUTO
LOW FAN MED FAN HIGH FAN AUTO
SET
MODE FAN SWING
TEMP
CLOCK
TIMER
SET
SLEEP
FILTER RESET
RESET
ON/OFF
HEAT
5
1
4
3
2
3
8
Hints:
The wire controller can memorize the working condition of each time. When start the unit for the second
time, just need to press ON/OFF button, the air conditioner will work according to the previous working
mode. (except for Timer, Sleep and Swing)
Operation instruction
Auto/Cooling/Dehumidifying/Heating operation
Turn on the unit
Press the ON/OFF button to turn on the unit
The LCD display of the wire controller will
show the previous working state (except for
TIMER, SWING, SLEEP mode). The
operation indicator light on the wire controller
will light up.
3
1
Choose of working mode
Press MODE button, each press the working
mode will change as the following sequence:
then choose AUTO, COOLING,
DEHUMIDIFYING, HEATING operation.
Set temperature
*Each press , the set temperature will
increase 1 degree.
*Each press, the set temperature will
decrease 1 degree.
Set the desired temperature.
Press the TEMP. SET button
Adjusting FAN SPEED
Press the FAN SPEED button, for each press,
the fan speed will change as the following
sequence:
Choose the desired fan speed.
In Heating operation, after start the
unit, the air conditioner will sending
warm air a moment later to prevent
the cold air blowing out. In
Dehumidifying, when the room
temperature drops 2* higher than
the set temperature, regardless the
set fan speed, the air conditioner
will intermittently operate in low
fan speed.
4
5 Turn off the unit
Press the ON/OFF button to turn off the
unit.
The wire controller only shows the clock
and room temperature.
2
Set temperature + 2*
Set temperature
When room temperature
reaches set temperature
+ 2*, the unit will operate
in mild dehumidifying
operation.
Ultra-low air flow
W h e n r o o m
temperature is higher
than set temperature,
unit in COOLING
operation.