HP 2500CMHP - Manual (Page 12)

3
8
1. Make sure that the Ink Cartridge Door is open. Grasp the side of the
Printhead Access Cover and lift up firmly to snap the cover open and
completely remove it from the printer. You may have to use some force
to open the cover.
Note: If the cradle cannot be found under the cover, it means that the tape
securing the cradle has not been removed. Open the Top Cover, remove the tape
securing the cradle, turn off the printer and turn on again.
2. Make sure the printer is turned ON.
The cradle will move away slightly. Open the purple printhead latch by
lifting the latch from the rear. Pull the latch forward and down to
release the latch hook from the purple carriage lock. Then lift and
push the latch toward the back of the printer.
3. Remove each printhead from its package.
Remove the protective tape from each printhead.
Insert each printhead into its own color-coded socket.
Push the printheads down firmly.
2500C/C+/CM HP Step 6 - Install Printheads
1
2