Honeywell SMV 3000 - Manual (Page 146)

134 SMV 3000 Transmitter User’s Manual 1/99
11.4 Diagnostic Messages,
Continued
Diagnostic Messages,
continued
Table 34 Informational Status Message Table
SMV Status SCT Status Message SFC Display Message TDC Status Message Possible Cause What to Do
6-3 2 Wire TC PV3 STATUS TAG ID.
2 WIRE TC PV3
2 WIRE TC PV3 PV3 input is being provided by
2-wire Thermocouple (T/C) type. Nothing – Information only. However,
this may indicate a problem if sensor
type does not match the sensor
physically connected to transmitter.
6-0 2 Wire RTD PV3 STATUS TAG ID.
2 WIRE RTD PV3
2 WIRE RTD PV3 PV3 input is being provided by
2-wire RTD type. Nothing – Information only. However,
this may indicate a problem if number
of wires displayed does not match
number of RTD leads physically
connected to transmitter; or if sensor
type should be thermocouple.
6-1 3 Wire RTD PV3 STATUS TAG ID.
3 WIRE RTD PV3
3 WIRE RTD PV3 PV3 input is being provided by
3-wire RTD type. Nothing – Information only. However,
this may indicate a problem if number
of wires displayed does not match
number of RTD leads physically
connected to transmitter; or if sensor
type should be thermocouple.
6-2 4 Wire RTD PV3 STATUS TAG ID.
4 WIRE RTD PV3
4 WIRE RTD PV3 PV3 input is being provided by
4-wire RTD type. Nothing – Information only. However,
this may indicate a problem if number
of wires displayed does not match
number of RTD leads physically
connected to transmitter; or if sensor
type should be thermocouple.
4-3 PV2 Sensor = AP - STATUS 4-3 Sensor type for the current SMV
is absolute pressure. Nothing – Information only.
4-4 PV2 Sensor = GP - STATUS 4-4 Sensor type for the current SMV
is gauge pressure. Nothing – Information only.
- Write Protected URV 1 . TAG ID.
WRITE PROTECTED
- The value could not be written
because the transmitter is write
protected. The hardware jumper within the
device must be repositioned in order
to permit write operations.