Honeywell SMV 3000 - Manual (Page 58)

SMV 3000 Transmitter User’s Manual 1/99 46
6.1 Introduction,
Continued
ATTENTION Please verify that you have the SCT software version that is compatible
with your SMV 3000. Refer to the table on Page 1.
To check the software version, connect an SFC or SCT to the transmitter,
(see Figure 28 for typical SFC and SCT connections).
Using the SCT: Perform Upload of the SMV database to the SCT. The
SMV firmware version can be read from the Device tab
card.
To check the SCT software version, select About SCT
from the Help pull down menu. The software version
will be displayed.
Using the SFC: Press SHIFT and ID keys. Wait for upload of transmitter
configuration to SFC.
Then press
SHIFT and 3 . The software version for the
SFC and SMV will be displayed.
SCT On-line Help and
User Manuals IMPORTANT: While the information presented in this section refers to
SMV 3000 transmitter configuration using the SCT 3000
software program, the SCT on-line manual and help
topics contain complete information and procedures on
SMV 3000 configuration and should be followed to
properly configure the transmitter.
This section of the manual should be viewed as
subordinate to the SCT on-line manual and if
inconsistencies exist between the two sources, the SCT
on-line manual will prevail.
Supplemental reference information is presented in this
section.
To Print On-line
Manual and Help
Topics The sections of the SCT on-line manual and help topics can be printed out
for your reference.
1.
Select Contents or User Manual from the Help pull down menu of the
SCT application window.
2. Go to the Contents tab.
3. Select a section or topic you wish to print out.
4. Click on the Print . . . button.