Honeywell TC150 User Manual

Page 11

Advertising
background image

21

21

MANUAL SETTINGS

CLOCK

• Press and hold MODE button for 3 seconds: the language letters

will flash.

• Press UP (▲) or DOWN (▲) to change flashing letters.
• After the first value is set, press MODE button again to move to

the next value

• Continue setting temperature in Celsius or Fahrenheit, year,

month, date, calendar format, 12 or 24 hour time format, hour
and minutes.

• Press MODE for the last time to return to the default mode (time

of day with seconds) after the last parameter is set.

TIME ZONE

• Select Time Zone setting mode by pressing MODE button until

the word “ZONE” will appear to the left of time display

• Press and hold MODE button until flashing“0:00” digits will

appear prompting to set the desired time zone in 30 minutes
intervals

ALARMS

HIGH RAIN ALARM
The high rain alarm for the past 24 hours can be set and displayed at any
time by pressing ALARM button on the front panel.
To set the high rain alarm,

• Press the ALARM button on the front panel until the “ALARM HI

will appear on the upper right corner of the rainfall information
line.

• Press and hold the ALARM button for 2 seconds or until the

rainfall data digits will flash.

22

• Enter the rainfall amount you want to set the rain alarm for using

the front panel UP (S) or DOWN (T).

• Press the ALARM button again to confirm and the high rain

alarm will be set.

NOTE: Press and hold the MODE button on the front panel to display the
rainfall reading in inches or mm.
TIME ALARMS
The Wireless Rain Gauge has three available time alarms – Weekday
alarm (W), Single alarm(S) and Ice Warning Alarm (Pre-Al).

• If Weekday alarm is activated, it will sound at the set time and

the alarm icon will flash Mondays through Fridays.

• If Single day alarm is activated, it will sound at the set time and

the alarm icon will flash only for this specific day and will not
activate on subsequent days.

• If Ice Warning Alarm is activated, in will sound at the set time

and alarm icon will flash if the remote temperature for Channel
One (1) will reach 35.6°F(+2°C) and below.

NOTE: Ice Warning Alarm can be set only if one or both of the
Weekday or Single alarm are programmed.
SETTING THE WEEKDAY AND SINGLE DAY ALARMS

• Press ALARM button once to enter into the alarms setting mode.

The default alarm is a Weekday alarm. The abbreviation “OFF
with a letter “W” next to it will be displayed, if the alarm has not
been set previously.

• Press and hold the ALARM button for two seconds. The hour

digit will flash.

• Enter the hour using back panel UP (S) or DOWN (T).
• Press the ALARM again. The minute digits will flash.
• Enter the minutes using UP (S) or DOWN (T).

Advertising