Honeywell TC150 - Manual (Page 8)

15
15
REMOTE TEMPERATURE SENSOR
NOTE: Install the batteries; select the channel and temperature in C°
or F° before mounting the remote temperature sensor.
• Remove the screws from the battery compartment with a small
Phillips screwdriver.
• Set the channel. The switch is located in the battery
compartment. Channel 1 is typically selected if only one remote
sensor is being used.
• Install 2 “AA” size alkaline batteries (not included) matching the
polarities shown in the battery compartment.
• Replace the battery compartment door and secure the screws.
• Secure remote temperature sensor in the desired location.
MAIN UNIT
• Open the battery compartment door.
• Install 2 batteries (UM-3 or “AA” size 1.5V) matching the polarity
as shown in the battery compartment.
• Replace the battery compartment door.
LOW BATTERY WARNING
A low-battery indicator [ ] will appear on the remote rainfall reading
line and the indoor or remote temperature reading line of the main unit,
warning that the corresponding batteries need replacement.
16
HOW TO USE THE TABLE STAND
The main unit has a removable table stand that supports it on the flat
surface.
Attach table stand to the bottom of the main unit in the slots provided.
The main unit can also be mounted on the wall using the recessed screw
hole. The table stand must be removed prior to mounting. The remote
temperature sensor can be similarly mounted or placed on a flat surface.
GETTING STARTED
After batteries are installed; remote temperature sensor will transmit
temperature readings at about 45 second intervals. The remote rain
gauge will transmit rainfall data at about 183 second intervals. The main
unit may take up to two minutes to receive the initial readings. Upon
successful reception, the rainfall reading (0.00) will appear on the top line
of the main unit’s display and the remote temperature will appear on the
line below. The main unit will automatically update readings at 45-second
intervals.
If no signals received from the remote temperature sensor within two
minutes, dashes [- - -] will be displayed.
Press and hold the front panel DOWN (▼) button on the main unit for two
seconds or until Rain symbol will start flashing, to initiate a signal search
for the remote rainfall.
Press and hold the back panel DOWN (▼) button on the main unit for
two seconds to initiate a signal search for the remote temperature.