Humminbird 530511-3_A - Manual

Trolling Motor Mount Installation
Attaching the Transducer to
the Trolling Motor
Trolling Motor Mounted Transducer
1
530511-3_A
Thank You
Thank you for choosing Humminbird®, America's #1 name in fishfinders. Humminbird® has built its reputation by
designing and manufacturing top-quality, thoroughly reliable marine equipment. Genuine Humminbird® accessories
offer the opportunity to upgrade and expand the capabilities of your Humminbird® product.
Your Humminbird® accessory is designed for trouble-free use in even the harshest marine environment. In the unlikely
event that your Humminbird® accessory does require repairs, we offer an exclusive Service Policy - free of charge
during the first year after purchase, and available at a reasonable rate after the one-year period. For complete details,
see the Warranty section included in this manual.
Contact our Customer Resource Center at either 1-800-633-1468 or visit our Web site at humminbird.com.
Installation Overview
Following are instructions for the installation of this accessory. Before you start installation, we encourage you to read
these instructions carefully in order to get the full benefit from your Humminbird® accessory.
If you find that any items are missing from your installation kit, call our Customer Resource Center at 1-800-633-1468
or visit our Web site at humminbird.com.
In addition to the hardware supplied with your transducer, you will need various hand tools.
Installation
The trolling motor transducer is designed to mount on the trolling motor of your boat. All hardware needed for
installation and operation of this Humminbird® accessory is either included with this accessory or came with your
original transducer. The trolling motor mounted transducer allows you to gather sonar information from the point on
the boat closest to where you are fishing. It is important that you properly orient the transducer housing in the
direction of travel of the trolling motor, to ensure an accurate depiction of the terrain under your boat.
The trolling motor mounted transducer will fit any standard trolling motor housing. Some users install this transducer
in conjunction with a switch so that the standard transducer can be used for high-speed operation, and the trolling
motor transducer can be used while trolling.
1.
Attaching the Transducer
WARNING! Before attaching the transducer to the trolling motor, confirm that the motor is disconnected from all sources of
electrical power.
CAUTION! Before attaching the transducer to the trolling motor, make sure the trolling motor is properly secured to the boat
and will not shift during transducer installation.
1. Position the transducer on the underside of the motor housing. Refer to the illustration that most resembles your
accessory, noting any requirements for directional bias.
NOTE: Round, circular-bottomed transducers have no directional bias, and therefore orientation of these types of
transducers is not as important. Rounded rectangular transducers, however, do have a directional bias, and must be
installed as shown in the illustration.
Side View of the Transducer
Transducer should be mounted forward of the motor shaft. Styles of transducer may differ from illustration.
NOTE: Your transducer may not look exactly like the transducer shown in the illustrations, but it will mount in exactly the
same way.
© 2011 Humminbird®, Eufaula AL, USA.
All rights reserved.
Temp
probe
Cable slots
NOTE: The transducers shown below
have no directional bias.
NOTE: The transducers shown below
have a directional bias, and therefore
need to be oriented according to
the illustration below.