Harbor Freight Tools 40315 User Manual

Page 15

Advertising
background image

SKU 40315

For technical questions, please call 1-800-444-3353.

Page 15

INSPECTION, MAINTENANCE, AND CLEANING

1.

WARNING! Always turn the Tool Saw’s Power Switch (21) to its “OFF” po-

sition and unplug the tool from its electrical outlet and before performing any
inspection, maintenance, or cleaning.

2.

Before each use: Inspect the general condition of the Tile Saw. Check for mis-
alignment or binding of moving parts, loose, cracked or broken parts, damaged
Power Cord, and any other condition that may affect its safe operation. If a problem
occurs with the Tool Saw, have the problem corrected before further use. Do not
use damaged equipment.

3.

To install a Cutting Wheel Blade (8):

A. Make certain power is disonnected and the power switch is in the “OFF” posi-

tion.

B. Empty the Tray (17). Turn it 90° (sideways) and remove it.

C. Remove the Screws (2) and Washers (3). Remove the Front Cover (1), and Rear

Blade Cover (58).

D. Use the prongs on the Spanner Wrench (59) to hold the Outside Flange (7) while

you use the Nut Driver (60) to remove the Nut (4). Remove the old Cutting Wheel
Blade.

E. Install a new 7” diameter, 1” round arbor hole, wet, diamond-bonded Cutting

Wheel Blade rated at a minimum of 8500 RPM.

F. Replace the Outside Flange (7) and Nut (4). Use the Spanner (59) to hold the

Outside Flange (7) while you tighten the Nut (4) securely with the Nut Driver
(60).

G. Replace the Front Cover (1), Rear Blade Cover (58), Screws (2), Washers (3),

and Tray (17) in the reverse order of removal.

4.

To clean: Wipe with a damp cloth, vacuum or use compressed air. Do not use
solvents.

5.

When storing: Store the Tile Saw in a safe, clean, dry, location out of reach of
children and other unauthorized people.

6.

CAUTION! All maintenance, service, or repairs not listed in this manual are

only to be attempted by a qualified service technician.

REV 03/06

Advertising