Connecting the wires, Connecting audio and alarms, Figure 2-3 – Honeywell EQUIP HD3MDIHX User Manual

Page 19: Audio and alarm pins, Table 2-1, Audio and alarm connector pin definitions

Advertising
background image

HD3MDIH/X EQUIP Series Indoor High Resolution True Day/Night IP Dome Camera User Guide

Document 800-07361 Rev A

19

12/10

2. Pre-drill the holes as indicated on the template, using the recommended hole size for

the screws being used.

Note

Other fasteners (preferably stainless steel) can be used, provided they are not
larger than the screw holes on the mounting template.

Connecting the Wires

Caution

Installation must be performed by a qualified electrician. The power
wire size for the distance and the number of cameras must be
determined to maintain 24 VAC at each camera.

Connecting Audio and Alarms

1. Pull the wires through the ceiling or wall hole until you have at least 4 inches of wire.
2. Remove the green connector strip (see

Figure 2-6

on

page 22

) from the camera base

and make all the necessary alarm and audio connections.

3. Connect a twisted pair (UTP) cable from each peripheral alarm contact to each alarm

input on the terminal block, as shown in

Figure 2-3

and

Table 2-1

.

Figure 2-3

Audio and Alarm PINs

1

2

3

4

5

6

7

8

Power

Table 2-1

Audio and Alarm Connector PIN Definitions

PIN

Definition

1

Audio In +

2

Audio In -

3

Audio Out +

4

Audio Out -

5

Alarm In +

6

Alarm In -

7

Alarm Out +

8

Alarm Out -

Advertising
This manual is related to the following products: