Connecting to a video monitor, Connecting to a network via, An rj-45 ethernet connector – Honeywell EQUIP HD3MDIHX User Manual
Page 23
HD3MDIH/X EQUIP Series Indoor High Resolution True Day/Night IP Dome Camera User Guide
Document 800-07361 Rev A
23
12/10
Connecting to a Video Monitor
The local video out (see
) is available as a test output and should be used as
needed during installation to position, aim, and focus the camera. Use the provided BNC
connector to connect the video from the camera to the video input connector on your video
monitor.
Note
If your installation involves a 24V AC power source, then please wait
approximately 60 seconds after connecting to a power source for video to
appear on the local video out.
Connecting to a Network via an RJ-45 Ethernet Connector
The main video connection for your HD3MDIH/X camera will be made through your
Ethernet network connection. Connect the Ethernet connector on your camera to your
network using an Ethernet (10Base-T, 100Base-TX) cable.
Note
You can connect your camera to a network or use any type of CAT5 cable to
connect it directly to a PC or laptop.