Flush mount (with or without 4s box), Restore factory defaults, Adjusting the camera fov (field of view) – Honeywell EQUIP HD3MDIHX User Manual

Page 25: E camera’s field of view (see

Advertising
background image

HD3MDIH/X EQUIP Series Indoor High Resolution True Day/Night IP Dome Camera User Guide

Document 800-07361 Rev A

25

12/10

Flush Mount (with or

without 4S box)

1. Use the screws (not supplied) to

connect the adapter plate directly
to the ceiling or wall.
Or
Use your own screws to connect
the adapter plate to the 4S box (not
supplied) which is attached to the
ceiling or wall.

Note

You must use screws that are
able to support at least three
times the weight
of the camera.

2. Connect the wires (see

Connecting

the Wires

on page

19

).

3. Secure the camera assembly to the

adapter plate by twisting clockwise
until it clicks securely in place.

4. Adjust the camera’s field of view

(see

Adjusting the Camera FOV

(Field of View)

on page

25

).

5. Install the turret by clicking it into place.
6. Install the dome bubble by placing it on the camera with the tabs to the left of the

slots, then turning it clockwise until the tabs click securely into place.

Restore Factory Defaults

Your HD3MDIH/X camera has a Factory Reset switch located inside the camera (see

Figure 2-6

on

page 22

). This switch restores your camera settings and passwords to their

default settings. Press and hold the Reset switch for three seconds. This will reset the
factory-configured parameters such as the compression settings, the camera tamper
detection settings, and the Video Motion Detection settings. This will not impact network IP
address configurations.

Adjusting the Camera FOV (Field of View)

To adjust your HD3MDIH/X camera:
1. Verify that power is supplied to your camera.

Dome bubble

Adapter plate

Camera
assembly

Turret

Note

Installation with 4S box shown

4S box (not supplied and optional)

Screws
(supplied)

Screw caps

Advertising
This manual is related to the following products: