Updating ip network settings automatically, Updating ip network settings manually – Honeywell EQUIP HD3MDIHX User Manual

Page 37

Advertising
background image

HD3MDIH/X EQUIP Series Indoor High Resolution True Day/Night IP Dome Camera User Guide

Document 800-07361 Rev A

37

12/10

Updating IP Network Settings Automatically

1. In the Discovery pane, select the device and click Connect

.

2. From the System tab click the Obtain an IP Address automatically check box.
3. Enter a Device Name, for example, FrontLobbyDome01

.

4. Click Apply.

The network automatically assigns the IP Address based on the DHCP network server
details. If no DHCP server is present on the network, the hardware defaults to an
APIPA address (169.254.x.x).

Updating IP Network Settings Manually

Caution

When manually updating the network settings, it is important to enter
the correct IP network settings before applying them. Incorrect values
might cause a failure when connecting to the device. See

Table 3-4

for definitions of each setting.

1. In the Discovery pane, select the device, and click Connect

.

2. To assign a static IP address to the device, from the System tab click to clear the

Obtain an IP Address automatically check box.

3. Enter a Device Name, for example, FrontLobby01.

Note

The MAC address is a factory-assigned address that is unique for each
device.

4. Enter an IP Address of the device on the network.

Note

The address must be in the same address range. For example, if the PC is
192.168.1.xx, then the device should be set to a similar address, for example
192.168.1.xy.

5. Enter the device Subnet Mask value. A value is required.
6. Enter a default Gateway Address that connects the device to the static network. A

value is required.

7. Click Apply.

The network settings are updated and a message displays in the status bar to confirm
the update.

Advertising
This manual is related to the following products: